Front Bumper

The photos for this page could not be recovered, but the text is intact.

Start by removing the front panel. It is held by four T20 torx screws at the top with the lower edge simply clicked into place.

Start from one end and gently prise the out as the clips release - use a flat blade to ease the clips out whilst pulling on the bumper gently.

and this is the front panel after removal

and after removing the front panel you are left with this

hinged rubber flaps cover two hidden bolts each side

standing at the front of the car - left side

standing at the front of the car - right side

hinged flap unclipped to reveal T30 bolt heads

10mm hex head bolt - after removing wheel arch liner

three more T30 torx screws here, on top

and two (or four) more torx screws here, underneath